CRM Mitchell1

Home / Archives for CRM Mitchell1 / Page 55

We Service and Repair all CRM Mitchell1 cars

  • 2006 Scion xB

    Scion xB
    Mileage
    202,192
    Service Date
    9/28/2020
    Services Performed
    • BELT CAME OFF, WE CHECKED ALL THE BELT DRIVEN PULLEYS AND THEY LOOK OK. WE INSTALL A NEW BELT, CHECK THE SYSTEM OPERATION AND FOUND COMPRESSOR IS OPERATING NORMAL AT THIS TIME.
    • REMOVE AND REPLACE RADIATOR CAP AND FILLER NECK
     
    BARNEY G. gave our service a 5 star review on 10/22/2020
  • 2016 Kia Sorento

    Kia Sorento
    Mileage
    37,643
    Service Date
    10/19/2020
    Services Performed
    • Quote is for 5 quarts of Multi-grade synthetic motor oil per manufacturer specifications, additional quarts, grades extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
    • –Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
    • SEE BELOW
    • STABILIZER BAR CONTROL LINK – Remove & Replace – Both Sides
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    JAMES W. gave our service a 5 star review on 10/20/2020
  • 2011 Mercedes-Benz C300

    Mercedes-Benz C300
    Mileage
    182,571
    Service Date
    10/17/2020
    Services Performed
    • IGNITION SWITCH – Remove & Replace – All Applicable Models
    • Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required
    • STEERING LOCK – Remove & Replace – All Applicable Models
     
    VIRGINIA B. gave our service a 5 star review on 10/20/2020
  • 2016 Nissan Altima

    Nissan Altima
    Mileage
    92,197
    Service Date
    10/14/2020
    Services Performed
    • AUTOMATIC CVT TRANSAXLE FLUID – INSPECT BRAKE LINES & CABLES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration, and signs of leaking. Replace any deteriorated or damaged parts immediately.] BRAKE SYSTEM – INSPECT – [Brake pads, rotors, drums & linings: Check for wear, deterioration and fluid leaks. Replace any deteriorated or damaged parts immediately.] DRIVESHAFT BOOTS – INSPECT AIR CLEANER ELEMENT – REPLACE CABIN AIR FILTER – REPLACE ENGINE OIL & FILTER – REPLACE TIRES – ROTATE – [When rotating tires, check for damage and uneven wear. Replace if necessary.]
    • PERFORM TRANSMISSION FLUID DRAIN AND REFILL
    • –Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
    • Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required Found code p0715 input speed sensor malfunction / see below
    • SPEED SENSOR – Remove & Replace – Input Speed Sensor – [Includes: R&I Starter Assembly.] – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
    • USING THE POWER STEERING FLUID EXCHANGE MACHINE USING 2 QUARTS OF POWER STEERING FLUID PERFORM A FLUID EXCHANGE
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    WALKER C. gave our service a 5 star review on 10/14/2020
  • 2011 BMW 528i

    BMW 528i
    Mileage
    191,975
    Service Date
    10/14/2020
    Services Performed
    • Quote is for 5 quarts of Multi-grade synthetic motor oil per manufacturer specifications, additional quarts, grades extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    AIDA G. gave our service a 5 star review on 10/14/2020
  • 2013 Fiat 500c

    Fiat 500c
    Mileage
    116,066
    Service Date
    10/9/2020
    Services Performed
    • AIR CLEANER ELEMENT – Remove & Replace – All Applicable Models
    • CABIN AIR FILTER – Remove & Replace – All Applicable Models
    • COMPRESSION TEST RESULT: CYL #1 190 CYL #2 190 CYL #3 185 CYL #4 185 – COMPRESSION UP TO SPECS.
    • OIL PRESSURE AT 80PSI COLD 40PSI WARM – AT SPECS.
    • Quote is for 7 quarts of Multi-grade synthetic motor oil per manufacturer specifications, additional quarts, grades extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
    • Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required/ SCANNED THE COMPUTERS AND FOUND CODES P0301 CYLINDER #1 MISFIRE, P1061 CYLINDER OIL SUPPLY SOLENOID VALVE STUCK, P1065 CYLINDER OIL SUPPLY OUT OF RANGE. WE FOUND SPARK PLUGS WERE FOULED AND THE ENGINE OIL LEVEL WAS LOW. RECOMMEND PERFORM OIL CHANGE SERVICE, REPLACE SPARK PLUG. PERFORM COMPRESSION TEST AND OIL PRESSURE TEST.
    • VALVE COVER GASKET – Remove & Replace – Turbocharger(LEAKING SPARK PLUG TUBE SEALS)
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    JOHN G. gave our service a 5 star review on 10/9/2020
  • 2014 Honda Civic

    Honda Civic
    Mileage
    66,206
    Service Date
    10/6/2020
    Services Performed
    • Quote is for 5 quarts of Multi-grade synthetic motor oil per manufacturer specifications, additional quarts, grades extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
    • REMOVE AND REPLACE THE AIR FILTER AND CABIN AIR FILTER
    • REMOVE AND REPLACE THE SERPENTINE BELT
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    SHANE O. gave our service a 5 star review on 10/6/2020
  • 2018 Toyota RAV4

    Toyota RAV4
    Mileage
    26,339
    Service Date
    9/23/2020
    Services Performed
    • –Read OBDII diagnostic codes – NONE –Check for leaks and note if fluid level low – NONE –Check the front and rear brakes – 6MM FRONT AND REAR BRAKES 11MM REMAINING –Check cruise control for proper operation – OK –Check vehicle electronics for proper operation – OK –Inspect the brake master cylinder and brake flex hoses – OK –Inspect the brake calipers and wheel cylinders – OK –Pressure test the cooling system and check for excessive hydrocarbons using the 5 gas anylizer – PASS –Load test the battery – PASS –Light inspection – OK –Inspect the outside drive belts -OK –Inspect the coolant hoses – OK –Inspect the front and rear shocks and or struts – OK –Inspect the front and rear suspensions – OK –Inspect constant velocity joint boots – OK –Inspect the steering linkage – OK –Inspect the exhaust system – OK –Inspect the transmission and differential fluid -with the exception of non-dipstick transmissions -OK –Inspect the tires, tire pressure, and set to proper psi – 32 –Check the 4 X 4 operation – if applicable –Check the idle speed – where applicable –Check the clutch – where applicable –Check the A/C temp 39 –Check for visible damage to vehicle – SOME SCRATCHES –Road test the vehicle ***COMPRESSION TEST CAN BE PERFORMED AT AN ADDITIONAL CHARGE** ***NOTE: THIS PREPURCHASE INSPECTION CANNOT BE RESPONSIBLE FOR INTERMITTENT PROBLEMS THAT MAY NOT SHOW UP AT THE TIME OF INSPECTION, NOR CAN IT PROVIDE ANY WARRANTY THAT THE VEHICLE WILL STAY IN THE EXACT CONDITION AS IT WAS DURING THE INSPECTION. USED CARS ARE "USED" AND ANYTHING CAN BREAK AT ANY TIME AFTER OUR INSPECTION.
     
    TAMARA R. gave our service a 5 star review on 10/4/2020
  • 2004 Toyota Sienna

    Toyota Sienna
    Mileage
    156,391
    Service Date
    9/30/2020
    Services Performed
    • — Identify refrigerant in use and check for contamination — Evacuate and charge A/C system with refrigerant — Add ultra-violet A/C dye to system — Examine exposed hoses, tubing and connections for leaks — Examine compressor/clutch for damage/leaks** — Examine compressor for missing caps, proper labeling** — Rotate the compressor to determine if faulty — Examine the condensor coil for damage/restrictions/leaks — Examine the expansion device for damage or leaks** — Examine the accum./receiver/drier for damage or leaks — Check the drive belt system — Inspect fan clutch for leakage and bearing wear — Check fan clutch for proper operation — Inspect the cooling fan for bent or missing blades — Examine accessible electrical connections — Check system for leakage at a minimum of 50 psi — Check operation of the compressor clutch — Check operation of blower motor and air control doors ** If accessible LEAKS DETECTED: REAR AC SUCTION TUBE PARTS DEFECTIVE: NONE Final high side operating pressure reading: 180 PSI Final low side operating pressure reading: 34 PSI Final center air distribution outlet temperature: 36 DEGREES F
    • REPLACE THE REAR AC SUCTION HOSE (LEAKING)
     
    ELIZABETH S. gave our service a 5 star review on 10/1/2020
  • 2007 Toyota Sequoia

    Toyota Sequoia
    Mileage
    138,983
    Service Date
    9/30/2020
    Services Performed
    • CHECK WASHER FLUID SYSTEM – INOP (FOUND A DEFECTIVE WASHER SYSTEM PUMP)
    • CLEAN AND LUBE SLIDERS CLEAN SURFACE WHERE ROTORS MATE TO HUBS
    • Quote is for 5 quarts of Multi-grade non-synthetic motor oil per manufacturer specifications, additional quarts, grades, or synthetic oils extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
    • REMOVE AND REPLACE THE SERPENTINE BELT(CRACKED)
    • CALIFORNIA RECYCLING FEE
    • Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
     
    RHENEE A. gave our service a 5 star review on 10/2/2020