Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required// SCANNED THE CARS COMPUTERS AND FOUND CODE P0300 MULTIPLE CYLINDER MISFIRE. WE TESTED THE COMPONENTS AND FOUND DEFECTIVE COILS, PLUGS, WIRES, IGNITION MODULE.
IGNITION COIL – Remove and Replace – 3.8L Eng One – [Includes: Test.]
SPARK PLUGS – Remove and Replace – 3.8L Eng
SPARK PLUG WIRE SET – Remove and Replace – All Applicable Models – [Includes: Component test.]
Quote is for 5 quarts of Multi-grade non-synthetic motor oil per manufacturer specifications, additional quarts, grades, or synthetic oils extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
CALIFORNIA RECYCLING FEE
–Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
–Hook up fluid exchange machine to vehicle –Remove old transmission fluid –Install new transmission fluid –Unhook fluid exchange machine from vehicle –Road test vehicle
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
CALIFORNIA RECYCLING FEE
PERFORM A FUEL SYSTEM CLEANING
DENNIS H. gave our service a 5 star review on 3/13/2018
Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required
REPLACE THE CRANK POSITION SENSOR
REPLACE THE SERPENTINE BELT AND IDLER PULLEY
–Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
CASEY W. gave our service a 5 star review on 2/24/2018
— Identify refrigerant in use and check for contamination — Evacuate and charge A/C system with refrigerant — Add ultra-violet A/C dye to system — Examine exposed hoses, tubing and connections for damage/leaks — Examine compressor/clutch for damage/leaks** — Examine compressor for missing caps, proper labeling** — Rotate the compressor to determine if faulty — Examine the condensor coil for damage/restrictions/leaks — Examine the expansion device for damage or leaks** — Examine the accum./receiver/drier for damage or leaks — Check the drive belt system — Inspect fan clutch for leakage and bearing wear — Check fan clutch for proper operation — Inspect the cooling fan for bent or missing blades — Examine accessible electrical connections — Check system for leakage at a minimum of 50 psi — Check operation of the compressor clutch — Check operation of blower motor and air control doors ** If accessible LEAKS DETECTED: NONE AT THIS TIME PARTS DEFECTIVE: NONE AT THIS TIME Final high side operating pressure reading: 120 PSI Final low side operating pressure reading: 30 PSI Final center air distribution outlet temperature: 38 DEGREES F
– Inspect disk brake pads, front and/or rear – FRONT BRAKE PADS 1-2MM AND REAR 8MM – Inspect rear brake shoes if applicable – Inspect rotors for scoring – Inspect cylinder/boot for leaks – Inspect calipers – Inspect pad retainer condition – Inspect anti-rattle springs in bushings – Inspect wheel bearing end play – Inspect wheel free rotation
CLEAN AND LUBE SLIDERS CLEAN SURFACE WHERE ROTORS MATE TO HUBS
–Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
PERFORM A FUEL SYSTEM CLEANING
KEN K. gave our service a 5 star review on 2/20/2018
AUTOMATIC TRANSMISSION FLUID – INSPECT AXLE and SUSPENSION PARTS – INSPECT – [Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.] BALL JOINTS – INSPECT – Front BRAKE CALIPERS – INSPECT – [Check for wear, deterioration and fluid leaks. Replace any deteriorated or damaged parts.] BRAKE DISCS/ROTORS – INSPECT – Rotors – [Check for wear, deterioration and fluid leaks. Replace any deteriorated or damaged parts.] BRAKE LINES and CABLES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE PADS – INSPECT – [Check for wear, deterioration and fluid leaks. Replace any deteriorated or damaged parts.] DIFFERENTIAL FLUID – INSPECT DRIVE BELTS – INSPECT – [Inspect for wear, fraying or cracking and for proper tension. Replace any damaged drive belts.] EXHAUST SYSTEM – INSPECT – [Visually inspect the exhaust pipes, muffler and hangers for leaks, cracks, deterioration, and damage. Tighten connections or replace parts as necessary.] MANUAL TRANSMISSION FLUID – INSPECT STEERING GEAR/RACK – INSPECT – [Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.] STEERING LINKAGE – INSPECT – [Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.] SUSPENSION COMPONENTS – INSPECT – [Check for damage, looseness, and leakage of oil or grease. Under severe driving conditions, inspect more frequently.] CABIN AIR FILTER – REPLACE – Microfilter – [When driving for prolonged periods in dusty conditions, replace the filter more frequently.] ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE SPARK PLUGS – REPLACE PROPELLER SHAFT – INSPECT TRANSFER CASE FLUID – INSPECT
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
CALIFORNIA RECYCLING FEE
PERFORM A FUEL SYSTEM CLEANING
USING THE POWER STEERING FLUID EXCHANGE MACHINE USING 2 QUARTS OF POWER STEERING FLUID PERFORM A FLUID EXCHANGE
–Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
REMOVE AND REPLACE THE BATTERY
CALIFORNIA BATTERY FEE
CLEAN AND LUBE SLIDERS CLEAN SURFACE WHERE ROTORS MATE TO HUBS
EMILY C. gave our service a 5 star review on 2/9/2018