AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – One Side – [DOES NOT include alignment. NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.]
Quote is for 5 quarts of Multi-grade non-synthetic motor oil per manufacturer specifications, additional quarts, grades, or synthetic oils extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
CALIFORNIA RECYCLING FEE
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
AMANDA W. gave our service a 5 star review on 1/30/2021
Quote is for 5 quarts of Multi-grade non-synthetic motor oil per manufacturer specifications, additional quarts, grades, or synthetic oils extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
CALIFORNIA RECYCLING FEE
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
Leann L. gave our service a 5 star review on 1/29/2021
— Identify refrigerant in use and check for contamination — Evacuate and charge A/C system with refrigerant — Add ultra-violet A/C dye to system — Examine exposed hoses, tubing and connections for damage/leaks — Examine compressor/clutch for damage/leaks** — Examine compressor for missing caps, proper labeling** — Rotate the compressor to determine if faulty — Examine the condensor coil for damage/restrictions/leaks — Examine the expansion device for damage or leaks** — Examine the accum./receiver/drier for damage or leaks — Check the drive belt system — Inspect fan clutch for leakage and bearing wear — Check fan clutch for proper operation — Inspect the cooling fan for bent or missing blades — Examine accessible electrical connections — Check system for leakage at a minimum of 50 psi — Check operation of the compressor clutch — Check operation of blower motor and air control doors ** If accessible LEAKS DETECTED: NONE AT THIS TIME PARTS DEFECTIVE: AC RELAY FAILED / SEE BELOW Final high side operating pressure reading: 151 PSI Final low side operating pressure reading: 38 PSI Final center air distribution outlet temperature: 36 DEGREES F
Quote is for 5 quarts of Multi-grade non-synthetic motor oil per manufacturer specifications, additional quarts, grades, or synthetic oils extra — Drain and refill motor oil — Replace oil filter — Replace oil drain plug sealing washer if applicable
REPLACE THE A/C RELAY (FAILED)
REPLACE THE LEFT BRAKE LIGHT BULB (OUT)
CALIFORNIA RECYCLING FEE
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
JAIME B. gave our service a 5 star review on 1/25/2021
CLEAN AND LUBE SLIDERS CLEAN SURFACE WHERE ROTORS MATE TO HUBS
REPAIR THE LOW FUEL PRESSURE SENSOR CONNECTOR
Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required
JANELLE J. gave our service a 5 star review on 1/22/2021
CUSTOMER STATES THE VEHICLE DOES NOT START INTERMITTENTLY, IT MAKES A CLICK NOISE – CHECK AND ADVISE. WE FOUND THE STARTER FAILING INTERMITTENTLY, RECOMMEND REPLACE STARTER.
STARTER ASSEMBLY – Remove & Replace
JILL S. gave our service a 5 star review on 1/21/2021
PARKING BRAKE – ADJUST WINDSHIELD – CLEAN – [Clean inside of windshield in front of camera (Vehicles with camera for collision warning).] BRAKE HOSES & LINES – INSPECT – [Inspect for damage/leaks.] BRAKE PADS – INSPECT COOLANT LEVEL – INSPECT ENGINE COOLANT – INSPECT – [Check and adjust the engine coolant antifreeze rating and anti-corrosion agent.] FUEL FILTER – INSPECT – [Check for leakage and damage.] FUEL LINES – INSPECT – [Check for leakage and damage.] POWER STEERING FLUID – INSPECT SPARE TIRE – INSPECT – [Check spare tire pressure every two years or every 40,000 miles/64,000 kilometers] TIRES – INSPECT – [Check pressure, wear and condition.] TRANSAXLE FLUID – INSPECT – [Inspect Engine/Transmission/ Timing gear, check for leaks. In the event of a leak from the transmission, check the oil level.] WASHER FLUID LEVEL – INSPECT WINDSHIELD WIPER BLADE INSERTS – INSPECT BRAKE FLUID – REPLACE – [Recommended to replace every 36 months or 40,000 miles (if driven in mountainous areas or humid climates – every 12 months) at owner's request.] CABIN AIR FILTER – REPLACE – [Recommended to replace at least once a year or more often in heavy traffic or dirty/dusty areas.] ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE SERVICE INTERVAL INDICATOR/DISPLAY – RESET AIR CLEANER/ELEMENT – REPLACE – [Clean the air cleaner housing/replace filter. May be necessary to change more frequently when driving in dusty/dirty areas.]
CALIFORNIA RECYCLING FEE
Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
Chris R. gave our service a 5 star review on 1/18/2021
CHECK FOR A ROTATIONAL NOISE WHEN DRIVING – ADVISE
PERFORM A FUEL SYSTEM CLEANING
REPLACE BOTH BANK 1 OXYGEN SENSORS
REPLACE THE SPARK PLUGS (MISFIRE / FOULED)
Services performed by ASE certified technician: –Use of hand held scan tools and/or laptop computer programs to access trouble codes causing check engine light –Use of computer diagnostic programs –Use of internet subscription technical sites –Use of up to one hour of ASE certified technician's time to determine the source of the problem causing the trouble code –Most but not all check engine lights or other driveability problems can be determined by the Check Engine Light/Level 1 Diagnostic service –Sometimes additional diagnostics may be required FOUND FAULT CODES P0171 SYSTEM TOO LEAN BANK 1, P0300 RANDOM MISFIRE, P0305 CYLINDER 5 MISFIRE, P2097 DOWNSTREAM FUEL TRIM SYSTEM RICK BANK 1, P0131 O2 SENSOR CIRCUIT LOW BANK 1 SENSOR 1 AND P113D O2 SENSOR SLOW RESPONSE BANK 1 SENSOR 1. DUE TO FAILED BANK 1 OXYGEN SENSORS CAUSING EXCESSIVE FUEL DELIVERY, FUEL FOULED SPARK PLUGS AND EXCESSIVE CARBON BUILD UP / SEE BELOW
DANA P. gave our service a 5 star review on 1/18/2021
POWER STEERING HOSE – Remove & Replace – Pressure(LEAKING)
STEERING GEAR (COMPLETE) – Remove & Replace – [Includes: Adjust toe-in on Rack and Pinion type Steering Gears. NOTE: Deduct .4 if alignment is also performed.](LEAKING)
WE FOUND THE LEFT FRONT WHEEL BEARING MAKING NOISE – RECOMMEND REPLACE THE LEFT FRONT WHEEL BEARING.
WHEEL BEARING – Remove & Replace – Front,LEFT Side – [Includes: Replace Inner and/or Outer Bearings, Cups, Seals and repack (where applicable).](NOISY AND PLAY)
DUALTONE INVOICE#
DABBIE R. gave our service a 5 star review on 1/14/2021