2010 Toyota 4Runner
Mileage
126,026
Service Date
1/5/2021
Services Performed
- BALL JOINT & DUST COVERS – INSPECT – [Check the suspension and steering linkage ball joins for looseness and damage. Check all dust covers for deterioration and damage. Replace any deteriorated or damaged parts.] BRAKE DRUMS & LININGS – INSPECT – [Check the brake linings (shoes) and drums for scoring, burning, fluid leakage, broken parts and excessive wear. Replace any deteriorated or damaged parts.] BRAKE HOSES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE LINE PIPES – INSPECT – [Visually inspect for proper installation. Check for chafing, cracks, deterioration and signs of leaking. Replace any deteriorated or damaged parts.] BRAKE PADS – INSPECT – [Check pads for excessive wear. Replace any deteriorated or damaged parts.] DISC BRAKES – INSPECT – [Inspect thickness measurement and disc runout. Replace any deteriorated or damaged parts.] DRIVE BELTS – INSPECT DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – [Check the drive shaft boots and clamps for cracks, deterioration and damage. Replace any deteriorated or damaged parts and, if necessary, repack the grease.] ENGINE COOLING SYSTEM HOSES & CLAMPS – INSPECT EXHAUST PIPES & MOUNTS – INSPECT – [Visually inspect the exhaust pipes, muffler and hangers for cracks, deterioration and damage. Start the engine and listen carefully for any exhaust gas leakage. Tighten connections or replace parts as necessary.] FUEL LINES & CONNECTIONS – INSPECT – [Visually inspect for corrosion, damage, cracks and loose or leaking connections. Tighten connections or replace parts as necessary.] FUEL TANK BAND – INSPECT – [Visually inspect for corrosion, damage, cracks and loose or leaking connections. Tighten connections or replace parts as necessary.] FUEL TANK CAP GASKET – INSPECT – [Visually inspect for cracks, deterioration and damage and replace if necessary.] FUEL TANK VAPOR VENT HOSES – INSPECT RADIATOR & CONDENSER – INSPECT – [Inspect for damage, debris, dirt, insects and signs of leakage.] STEERING GEAR/RACK – INSPECT – [Check for damage/leaks.] STEERING LINKAGE & BOOTS – INSPECT – [With the vehicle stopped, check for excessive freeplay in the steering wheel. Inspect the linkage for bending and damage and the dust boots for deterioration, cracks and damage. Replace any damaged parts.] TRANSMISSION FLUID – INSPECT AIR CLEANER/ELEMENT – REPLACE CABIN AIR FILTER – REPLACE – [Driving in heavy traffic, on dirt roads or in urban, dusty or desert areas may shorten the life of the cabin air filter. Replacement may be needed if you notice reduced air flow from the air conditioner and heater or if the windows fog easily when you use the "Fresh" mode.] ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE SPARK PLUGS – REPLACE – [Maintenance services of spark plugs are required under terms of Emission Control Warranty.] ENGINE OIL REPLACEMENT REMINDER LIGHT – RESET – [Reset the oil replacement reminder ("MAINT REQD") light after replacing engine oil, if vehicle is equipped with this light.] PROPELLER SHAFT BOLTS – RETORQUE TIRES – ROTATE – [Check tire tread depth and for uneven or excessive wear.]
- –Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
- USING THE POWER STEERING FLUID EXCHANGE MACHINE USING 2 QUARTS OF POWER STEERING FLUID PERFORM A FLUID EXCHANGE
- CALIFORNIA RECYCLING FEE
- Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
JUBANI E. gave our service a 5 star review on 1/7/2021
