Mileage
73,989
Service Date
2/19/2018
Services Performed
- — Identify refrigerant in use and check for contamination — Evacuate and charge A/C system with refrigerant — Add ultra-violet A/C dye to system — Examine exposed hoses, tubing and connections for damage/leaks — Examine compressor/clutch for damage/leaks** — Examine compressor for missing caps, proper labeling** — Rotate the compressor to determine if faulty — Examine the condensor coil for damage/restrictions/leaks — Examine the expansion device for damage or leaks** — Examine the accum./receiver/drier for damage or leaks — Check the drive belt system — Inspect fan clutch for leakage and bearing wear — Check fan clutch for proper operation — Inspect the cooling fan for bent or missing blades — Examine accessible electrical connections — Check system for leakage at a minimum of 50 psi — Check operation of the compressor clutch — Check operation of blower motor and air control doors ** If accessible LEAKS DETECTED: NONE AT THIS TIME PARTS DEFECTIVE: NONE AT THIS TIME Final high side operating pressure reading: 120 PSI Final low side operating pressure reading: 30 PSI Final center air distribution outlet temperature: 38 DEGREES F
- – Inspect disk brake pads, front and/or rear – FRONT BRAKE PADS 1-2MM AND REAR 8MM – Inspect rear brake shoes if applicable – Inspect rotors for scoring – Inspect cylinder/boot for leaks – Inspect calipers – Inspect pad retainer condition – Inspect anti-rattle springs in bushings – Inspect wheel bearing end play – Inspect wheel free rotation
- CLEAN AND LUBE SLIDERS CLEAN SURFACE WHERE ROTORS MATE TO HUBS
- –Remove old brake fluid from reservoir –Check and clean the reservoir if applicable –Install new brake fluid –Power bleed the system
- Charges are for proper disposal of hazardous waste generated during repairs/ service to your motor vehicle. Such charges include but not limited to,all engine and drive train fluids and any other hazardous waste as described by law.
- PERFORM A FUEL SYSTEM CLEANING
KEN K. gave our service a 5 star review on 2/20/2018